Monitoring solar bracket installation diagram

How do I install a meter bracket?

1. Install the bracket with the semi-circles facing down, as shown below. Verify that the bracket is firmly attached to the mounting surface. If you are connecting the meter to a revenue grade inverter, refer to Installing Two Meters on page 19.

What tools do I need to install the SolarEdge system?

Standard tools can be used during the installation of the SolarEdge system. The following is a recommendation of the equipment needed for installation: Cordless drill (with a torque clutch) or screwdriver and bits suitable for the surface on which the inverter and optimizers will be installed and for opening the Safety Switch drill guides.

How do I connect my PV system to the Monitoring Platform?

Use one of the following methods to connect your PV system to the monitoring platform. Simple on-site registration of new systems. Creating, editing and verifying system physical layout. Scanning and assigning the power optimizer serial number to the correct location in the system physical layout.

How do I mount a meter?

Mount the meter on a wall or pole using the supplied bracket. 1. Install the bracket with the semi-circles facing down, as shown below. Verify that the bracket is firmly attached to the mounting surface.

How do I connect a Master inverter to the SolarEdge Monitoring portal?

To connect to the SolarEdge monitoring portal, designate a single inverter as the connection point between the RS485 bus and the monitoring portal. This inverter will serve as the master inverter. Connect the master to the SolarEdge monitoring portal via one of the communication options.

How do I install a SolarEdge meter?

Twist the wires together and insert them into the terminal. Securely tighten the terminal screws. 2. Terminate the SolarEdge device as described in Installing and Connecting the Meter on page 7. The built-in RGM is pre-configured as a production meter and its settings should not be changed.